how to replace iphone battery by yourself
How is the iPhone battery out and replace them with new iPhone battery is quite complicated and can be one of the cruelest things you expensive gadget with a primo, you can pretty much depend on the whole way. If you really want to try it, you should at least know your way around a soldering iron, as you need it mess around with some sensitive electronics, this hot tip. The most difficult part is how to remove the battery of the iPhone at first instead of the dead, only the coup de grace. Follow the instructions carefully and if you stop to doubt your ability to get it right. The following steps are specific need for the first and second generation iPhone, a spare battery for your iPhone, a small flat screwdriver and a Phillips screwdriver, a spudger (a removal tool for handling small components, are made mostly of nylon with a hook metal), a soldering iron and a lot of care and patience. Phase One: How to remove the battery of the iPhone removing the SIM tray by locating the small black hole near the socket for the headphones with a paper clip. This is to prevent damage when you open the outer cover. Here are removed the two screws on both sides of the loading station to the small Phillips screwdriver. Once you remove it, you can begin to back out of the envelope. Do not panic, but be careful anyway. The rear cover may be some force and bending to remove it. Use the screwdriver to create a wedge between the black plastic cover and the front of the iPhone. If you have a plastic wedge, you will probably have some damage to the cover. Lift from the back and push the case forward to release it. Carefully remove the ribbon cable that the case to the motherboard and set it aside to be reused after replacing your battery. Use the spudger on the LCD on the back by releasing it between the chrome ring and the front panel. Lift the display, and with the release spudger the black band with a "1". Remember to avoid solving this black cable to short circuit the board. Take the separation of the other flat ribbon cable. The spudger can be used to the white rider holds the cable to be solved. Remove the display and set aside. To remove the motherboard, you have to find and remove eight screws with the Phillips screwdriver. A screw should be removed as part of a warranty sticker. Finally, a ribbon cable to solve "4" and lift out the motherboard. It is connected by a band the one with the camera. Take the camera from the case in the back, but it will remain connected to the board.
replace iphone battery replace iphone 3g battery replace iphone 4 battery